Hi
It seems that there is no separate throttle hold pitch curve and it uses the current pitch from Idle up 0,1 or 2 - Have I missed something as its not what I am used to with my old Futaba radio
throttle hold curve
Re: throttle hold curve
Personally I use the idle up pitch curves which is -100 to 100. You can set up a separate pitch curve for throttle hold if you want to. You could do it like below:
Pitch channel
+100% THR Switch(ID0) Curve(C1) ** Normal mode curve here
+100% THR Switch(!ID0) Curve(C2) ** Idle up curves here
R100% THR Switch(THR) Curve(C3) ** this would be the curve used in throttle hold, Note this has to be a replace mix
-Gohst
Pitch channel
+100% THR Switch(ID0) Curve(C1) ** Normal mode curve here
+100% THR Switch(!ID0) Curve(C2) ** Idle up curves here
R100% THR Switch(THR) Curve(C3) ** this would be the curve used in throttle hold, Note this has to be a replace mix
-Gohst
Re: throttle hold curve
I did try that ( including replace) but it still used the Idle curve - will try again later to see if I can get it to work - does the order of mixes affect this ???
Re: throttle hold curve
If you have replace mixes, the lowest one in the list has priority. This is on a per output channel basis.
-Gohst
-Gohst
Re: throttle hold curve
that was it then - all works fine now