BeastX flybarless setup

Post Reply
User avatar
gohsthb
Posts: 1412
Joined: Wed Dec 28, 2011 2:32 pm
Country: -
Location: Naperville, IL

BeastX flybarless setup

Post by gohsthb »

from kgd1 on RcGroups,
Here you go I use this for my BeastX & CX-3X1000 FBL units
The only change I made was to save some eeprom space. I removed a duplicate pitch curve for ID2. ID1's curve is the same. This also allowed one mixer line to be removed as well.

-Gohst
Attachments
GAUIX5.eepm
(1.06 KiB) Downloaded 906 times

michaelgriffin
Posts: 13
Joined: Fri Aug 03, 2012 1:25 am
Country: -

Re: BeastX flybarless setup

Post by michaelgriffin »

I got my flybarless gear today, (ordered on Fri. received on Mon.) and looked at "gauix5.eepe". Don't I still need to use my 8 channel "flysky" rx? And isn't the throttle (esc) on channel 3?

Thanks!

Mike
User avatar
gohsthb
Posts: 1412
Joined: Wed Dec 28, 2011 2:32 pm
Country: -
Location: Naperville, IL

Re: BeastX flybarless setup

Post by gohsthb »

yes you will still need a receiver. The eepm file is set up with the Spektrum channel order TAER.
-Gohst
zul9x
Posts: 4
Joined: Thu Nov 22, 2012 2:07 am
Country: -

Re: BeastX flybarless setup

Post by zul9x »

I usually setup my beast x using futaba radio. And i fully understand on how to prgram beast x ..my friend ask me to setup his beast x with er9x firmware..any tips for me to setup beast x using this er9x..and im going to change my tx to flysky with er9x soon.hehe..we have to setup to 90 degree rght?..
Thankz in advance..
By the way.my name is zulhilmi from malaysia.currently using ftaba t6j and soon will replace my tx to this geat ptntial tx with mighty prgrmmng features when flash to er9x..
zul9x
Posts: 4
Joined: Thu Nov 22, 2012 2:07 am
Country: -

Re: BeastX flybarless setup

Post by zul9x »

gohsthb wrote:from kgd1 on RcGroups,
Here you go I use this for my BeastX & CX-3X1000 FBL units
The only change I made was to save some eeprom space. I removed a duplicate pitch curve for ID2. ID1's curve is the same. This also allowed one mixer line to be removed as well.

-Gohst
do we need to assign 'collective' in heli setup parameter? or just leave it blank

User avatar
Kilrah
Posts: 11108
Joined: Sat Feb 18, 2012 6:56 pm
Country: Switzerland

Re: BeastX flybarless setup

Post by Kilrah »

No, do not use the heli setup page with any FBL controller.
zul9x
Posts: 4
Joined: Thu Nov 22, 2012 2:07 am
Country: -

Re: BeastX flybarless setup

Post by zul9x »

Kilrah wrote:No, do not use the heli setup page with any FBL controller.
okay..will get back once i manage to setup my heli..

Post Reply

Return to “Helicoptor Programming”