Turnigy 9x and dx4e ?

Like DSM2/DSMX? Want to mod your radio to support it? Post your messages here!
Post Reply
RacingSOUL
Posts: 5
Joined: Wed Nov 28, 2012 6:45 am
Country: -

Turnigy 9x and dx4e ?

Post by RacingSOUL »

Hello everyone!
I'm new to all this stuff, please excuse my incompetence :oops: I need your help guys very much!

I have turnigy 9x with stock v2 firmware using which I fly wltoys v911 helicopter. I want to buy blade ncpx and want to control it with my 9x.

My goal is to make my 9x able to control both helicopters by switching between flysky and dsm modules (hardware switch). Is that possible to make? I have dx4e mainboard with dsm2/x module on it.

Thanks in advance!

User avatar
Kilrah
Posts: 11108
Joined: Sat Feb 18, 2012 6:56 pm
Country: Switzerland

Re: Turnigy 9x and dx4e ?

Post by Kilrah »

Instructions to install the DSM module are here, but those require you to reflash your radio first (you can't use it with stock firmware):
http://openrcforums.com/wiki/index.php/ ... M_protocol
There are 2 common methods, one is to install the module in the radio with a switch to route power/signal either to the back module or the DSM module, the other is to put the DSM module and its regulator in a 2nd JR module case, and to then swap the modules when needed.

For more info about reflashing, have a read through the Wiki. http://openrcforums.com/wiki/index.php/Main_Page
RacingSOUL
Posts: 5
Joined: Wed Nov 28, 2012 6:45 am
Country: -

Re: Turnigy 9x and dx4e ?

Post by RacingSOUL »

Thank you very much, Kilrah! I want to go the first route - "install the module in the radio with a switch to route power/signal either to the back module or the DSM module".

Will keep this thread updated with progress :)

Post Reply

Return to “DSM2/DSMX Mods”