Hi all, does anyone have any experiance with er9x and setting up Eagle tree osd pro with the er9x,
i want if i can use the 3pos switch for flaps and set up 2 others for the aux 1 and aux 2, which is easy but i can i add in a switch for RTH ?
i've tried it on the 3pos switch using it as aux 1 in 3posRTH mode but the rth is at the 2 pos meaning it invokes the menu, any ideas?
cheers in advance
Eagle Tree OSD Pro setup
-
- Posts: 1
- Joined: Thu Apr 04, 2013 12:02 pm
- Country: -
- Contact:
Re: Eagle Tree OSD Pro setup
For RTH function you will need to set and record first a fail safe position on the RX! After that, you will configure a switch to simulate this RTH condition, thus you can use aux1 for 3POSITION switch (using 1 channel), aux2 "guardian gain" for POTENCIOMETER (using more 1 channel) and another switch for simulate a failsafe.
Have a good luck!
Have a good luck!