One of my Er9x Tx's with r767 after being ON for a while starts giving three rapid beeps follwed by a 2 sec pause and then again 3 beeps etc... After another 4-5 minute it stops doing that.
My other Tx's do not do that. They are all supposed to have the same settings.
I checked things like timer, inactivity, voltage etc... but cannot see what causes this.
The manual has no beeper alarms explanation chapter AFAIK.
Can anyone tell me what those 3 beeps mean?
3 rapid beeps. Meaning?
-
- 9x Developer
- Posts: 2764
- Joined: Fri Dec 30, 2011 11:11 pm
- Country: -
Re: 3 rapid beeps. Meaning?
Perhaps a mix which has his Warning parameter set to 3 ? You would have 3 very short beeps regularly when enable.
Bertrand.
Bertrand.
- cre8tiveleo
- Posts: 1434
- Joined: Tue Dec 27, 2011 6:13 pm
- Country: -
- Location: Ontario,(GTA North)
- Contact:
Re: 3 rapid beeps. Meaning?
definitely hungry...
- ShowMaster
- Posts: 4327
- Joined: Thu Dec 29, 2011 3:44 am
- Country: -
- Location: Los Angeles, CA USA
Re: 3 rapid beeps. Meaning?
Things to try,
Select another memory or model and see if it goes away.
Reload the firmware and not your saved memories. See if it still happens by selecting the new blank model 1.
If it's OK save one memory mix that was doing it and see what happens.
ShowMaster
Sent from my iPod touch using Tapatalk
Select another memory or model and see if it goes away.
Reload the firmware and not your saved memories. See if it still happens by selecting the new blank model 1.
If it's OK save one memory mix that was doing it and see what happens.
ShowMaster
Sent from my iPod touch using Tapatalk
Re: 3 rapid beeps. Meaning?
What is your voltage alarm set to? And what is the tx voltage?
-Gohst
Sent from my LG-P999 using Tapatalk 2
-Gohst
Sent from my LG-P999 using Tapatalk 2