Hi everyone,
And many thanks to Mike and all other contributors for this amazing piece of software
I'm using er9x on a modded Turnigy 9X (m2561, telemetry, haptic and backlight mod) with an IRangeX IRX4+ multiprotocol module (serial mode) since several months now, all is working good.
I recently updated all softwares (er9x to v822n and Multiprotocol to v1.3.0.53) and I lost all names (the basic ones like the FRSKYX who was there before with v822m) in the protocol configuration page. Is this a standard behavior ? Is it possible to have them back ? (and possibly all of the multiprotocol supported ones) with the m2561 build ? Is there any possibility to get it done by myself and how ?
I've seen that names are intended to work when you add multi.txt to the root of an sdcard on other transmitters, but unfortunatly, mine doesn't have one as I don't plan to use the arduvoice module.
Thanks for pointing me in the right direction.
Turnigy 9X m2561 & Multiprotocol Module
-
- Posts: 3
- Joined: Tue Mar 10, 2020 12:35 am
- Country: France
Turnigy 9X m2561 & Multiprotocol Module
TGY 9X with m2561 under er9x, Telemetry & Haptic & Backlight mod enabled / IrangeX IRX4+ MultiProtocol module
- MikeB
- 9x Developer
- Posts: 17993
- Joined: Tue Dec 27, 2011 1:24 pm
- Country: -
- Location: Poole, Dorset, UK
Re: Turnigy 9X m2561 & Multiprotocol Module
Please try flashing the multiprotocol module with "MULTI_TELEMETRY" selected rather than "MULTI_STATUS". If you downloaded a pre-compiled version, use the one for openTx instead of the one for erskyTx.
The module should then send the protocol names to er9x for display.
Mike
The module should then send the protocol names to er9x for display.
Mike
erskyTx/er9x developer
The difficult we do immediately,
The impossible takes a little longer!
The difficult we do immediately,
The impossible takes a little longer!
-
- Posts: 3
- Joined: Tue Mar 10, 2020 12:35 am
- Country: France
Re: Turnigy 9X m2561 & Multiprotocol Module
Thanks Mike, it's working now.I was confused by the commentary in the MultiProtocol doc.
I hadn't realized it wasn't er9x related at all, that's why I shouldn't flash my gear past 1 a.m ^^
Again thank you for maintaining this project alive and kicking !
I hadn't realized it wasn't er9x related at all, that's why I shouldn't flash my gear past 1 a.m ^^
Again thank you for maintaining this project alive and kicking !
TGY 9X with m2561 under er9x, Telemetry & Haptic & Backlight mod enabled / IrangeX IRX4+ MultiProtocol module