Need to bind every time the TX16S is turned on.
Posted: Fri Aug 20, 2021 12:14 am
I bought a UMX Night Vapor (DMS2/X) today and got it setup on my Radiomaster TX16S running OpenTx v2.3.14 with the 1.3.2.86 firmware for the multi-module. When I bind the TX16S to the Night Vapor everything works exactly as expected. Telemetry comes back, the model flies (quite nicely!).
However, if I turn the radio off, I must bind again the next time I fly.
I set the receiver number to both 00 and 01 no change. If I keep the radio on, and power cycle the Vapor, everything works, no binding required. If I turn the radio off and keep the airplane on, binding is required.
I have another UMX plane loaded in my model list the Turbo Timber. It doesn't have this problem. It works between power cycles.
When I bind I choose DSM - Auto. Any ideas on what I might be doing wrong?
-Jim
However, if I turn the radio off, I must bind again the next time I fly.
I set the receiver number to both 00 and 01 no change. If I keep the radio on, and power cycle the Vapor, everything works, no binding required. If I turn the radio off and keep the airplane on, binding is required.
I have another UMX plane loaded in my model list the Turbo Timber. It doesn't have this problem. It works between power cycles.
When I bind I choose DSM - Auto. Any ideas on what I might be doing wrong?
-Jim