Graupner using multi protocol and external telemetry

[gquiring]

I have the RadioMaster TX16S and bound up some Graupner Hott receivers. The LUA script is impressive how you can view and change your settings like a Graupner radio does. My issue is the vario and possibly other sensors. I have a two Hott receivers one with an internal vario and a GR-16L with an external vario. When I do the discovery of the sensors they are not there.

Is there going to be any support to making these vario's work?

[Kilrah]

There's been some work done lately yes but not finished yet, HoTT support is somewhat basic at this point as mentioned on the MPM protocols page.

[Andrea76it]

Hi, I am also very interested in this project.
Because I have a lot of Graupner Hott Receivers and Sensors (like ESC).
I just bought an "iRangeX RX4 LITE" MPM, but I am also trying another solution, to build a telemetry converter from Hott to SmartPort, in order to directly connect my ESC Hott to the Frsky receiver.

Tell me how I can contribute to the project!

Andrea

[Kilrah]

HoTT telemetry should be pretty much fully working now on the current dev versions of both multi and OpenTX.

[Andrea76it]

Hi, but with the new versions is it possible to connect the HOTT sensors to the Smart Port or is it always necessary to use a Graupner receiver and a Multi Protocol Module?

[Andrea76it]

Where can I find some documentation? On the OpenTx or DiyMPM website there are only the new features introduced, but they do not explain how to use it. Do you have instructions?

[3djc]

You need a HoTT receiver to use HoTT sensors