Programming a throttle POSITION hold with, Taranis

Programing help and example for all firmwares based on thus's th9 firmware.
Post Reply
drewsterflyer
Posts: 2
Joined: Sun Oct 28, 2018 7:32 pm
Country: -

Programming a throttle POSITION hold with, Taranis

Post by drewsterflyer »

Trying to setup a switch on my Taranis X9D, V2.2 firmware, that allows me to activate a switch and HOLD THE CURRENT THROTTLE POSITION - useful when learning to hover a helicopter.

I have searched the web endlessly to no avail - plenty of articles on how to program a throttle 'kill' or 'disable' switch, but that is NOT what I am trying to achieve. I need a switch that will simply maintain the throttle signal at the last known throttle stick position until the switch is turned off.

Any ideas?

User avatar
Kilrah
Posts: 11108
Joined: Sat Feb 18, 2012 6:56 pm
Country: Switzerland

Re: Programming a throttle POSITION hold with, Taranis

Post by Kilrah »

If your throttle channel is CH3, then below the main line of CH3 add a REPLACE mixer line with 100%CH3 and the switch you want to activate the feature.

You obviously want to be extremely careful when setting this up and using it, and should always have a throttle kill with higher priority.
User avatar
jhsa
Posts: 19480
Joined: Tue Dec 27, 2011 5:13 pm
Country: Germany

Re: Programming a throttle POSITION hold with, Taranis

Post by jhsa »

Ch03 100% Thr
R 100% CH3 Switch (THR) (R means that this is a replace mix)

João
My er9x/Ersky9x/eepskye Video Tutorials
https://www.youtube.com/playlist?list=PL5uJhoD7sAKidZmkhMpYpp_qcuIqJXhb9

Donate to Er9x/Ersky9x:
https://www.paypal.com/cgi-bin/webscr?cmd=_s-xclick&hosted_button_id=YHX43JR3J7XGW
drewsterflyer
Posts: 2
Joined: Sun Oct 28, 2018 7:32 pm
Country: -

Re: Programming a throttle POSITION hold with, Taranis

Post by drewsterflyer »

Many thanks for the prompt response.
Think I have it sorted now!

Post Reply

Return to “er9x / gruvin9x / th9 based firmwares”