Migrating models sky9x -> taranis and taranis -> horus

A fork of eePe. It's aim is to provide one tool that works with ALL firmwares!
Post Reply
pcwizzul
Posts: 35
Joined: Mon Sep 24, 2012 2:54 pm
Country: -

Migrating models sky9x -> taranis and taranis -> horus

Post by pcwizzul »

Hi everybody, maybe it's been discussed already but I couldn't find anything. I'm migrating my models from a sky9x board to a taranis plus and I found no way to assign switches during conversion.
For example I'd like that in every model "gear up" from the sky9x is "switch G up" on the taranis? Is it possible to do it?
A friend of mine has the very same problem passing from taranis to horus
Thanks in advance

User avatar
Kilrah
Posts: 11108
Joined: Sat Feb 18, 2012 6:56 pm
Country: Switzerland

Re: Migrating models sky9x -> taranis and taranis -> horus

Post by Kilrah »

No, you have to edit each model separately as desired after the conversion.
pcwizzul
Posts: 35
Joined: Mon Sep 24, 2012 2:54 pm
Country: -

Re: Migrating models sky9x -> taranis and taranis -> horus

Post by pcwizzul »

I was afraid this was the answer....
This way we can't use the older radio as backup. Isn't there the possibility to add this to companion? It already makes some sort of conversion, it would be nice to let the user choose how to handle it.
What if I compile companion on linux? I wouldn't like going down that route but it could be doable, I suppose.
Thanks again
User avatar
Kilrah
Posts: 11108
Joined: Sat Feb 18, 2012 6:56 pm
Country: Switzerland

Re: Migrating models sky9x -> taranis and taranis -> horus

Post by Kilrah »

It's impossible to handle automatically, and in most cases people reassign their switches in completely different configuration when the number of them and the 2/3pos combinations change anyway.

Even just that people use the same switch for the same thing in all models is not an assumption that can be done.

Post Reply

Return to “companion9x”