A2 Telemtry voltage slowy increases over time.

All mods related to the frsky telemetry series of the firmware
Post Reply
glitch666
Posts: 2
Joined: Wed Jan 08, 2014 8:12 am
Country: -

A2 Telemtry voltage slowy increases over time.

Post by glitch666 »

Hi guys. So ill start with my setup, rev 816 FRSKY on my 9x. I just installed a modded djt module following the non converter guide. The receiver is a D4R-II hooked up to my Naze32 telemetry port. A1, RSSI and altitude work great. But if I set the voltage(increase it till I get the proper voltage that matches my battery) and let it sit for idk maybe 15-30 seconds the displayed voltage slowly increases, I the go back and lower it till its correct..... Then it slowy starts increasing again. Then if I reset everything my displayed voltage is really low and slowly goes up. I can never get it to stay at the correct voltage. Anybody ever deal with this issue?

User avatar
Kilrah
Posts: 11108
Joined: Sat Feb 18, 2012 6:56 pm
Country: Switzerland

Re: A2 Telemtry voltage slowy increases over time.

Post by Kilrah »

Do you actually have something connected to the receiver's A2 port?
I guess not, and you're just looking at the wrong value.

The Naze returns the voltage it measures into the VFAS field (see documentation of the Naze firmware you're using).
glitch666
Posts: 2
Joined: Wed Jan 08, 2014 8:12 am
Country: -

Re: A2 Telemtry voltage slowy increases over time.

Post by glitch666 »

Yah know what, im totally dumb today lol. VFAS works great, I dont know why I was trying A2. Thanks bud! Im using cleanflight and the telemetry documentation does not mention that.

Post Reply

Return to “FRSky Telemetry Mods”