Page 1 of 1

The Module

Posted: Fri Jul 03, 2015 11:42 am
by MikeB
The DSM telemetry module, that uses the internal antenna of the 9XR-PRO, is now available, see: http://www.hobbyking.com/hobbyking/stor ... ible_.html.

This is fully supported by ersky9x as installed on the 'PRO as delivered.

Mike.

Re: The Module

Posted: Tue Jun 07, 2022 7:29 pm
by OctavioS
Here is the updated link.
Is there any specific reason i cannot bind this module to the receivers below?
What happens is that, during the binding procedure, the light blinks fast, and then it slows, as if it was binding, but the light goes off and not solid. it simply wont bind.
I get a solid light with this module, but no movement.
The channel order is TAER.
Image

Re: The Module

Posted: Tue Jun 07, 2022 9:11 pm
by OctavioS
With these receivers and the 9xr pro with the orangerx module (9xr pro exclusive module) everything works fine.
With the same settings and the above receivers, nothing.

Re: The Module

Posted: Tue Jun 07, 2022 10:20 pm
by OctavioS
[SOLVED] The only reason for the receivers not binding was the fact the telemetry com port 1 was not inverted. I just inverted com port 1 and everything went fine. Even for the receivers that do not support telemetry, like the ones above, you need to invert that com port in the model telemetry menu.

Re: The Module

Posted: Wed Jun 08, 2022 6:42 pm
by MikeB
During bind, the Rx sends back to the Tx what bind mode it accepts. The Tx module passes this, using the telemetry connection, on so the radio then knows when the bind has completed, and also then keeps the bind mode so it is correct after a power cycle.

Mike

Re: The Module

Posted: Fri Jun 10, 2022 12:41 am
by OctavioS
Thx Mike. I would never guess that a receiver still uses telemetry com port for binding, even though it doesn't support telemetry. Now I know.