Hi all, I have a turnigy 9xr pro running firmware:
ersky9x-pf8r221
Transmitter module is Frsky DJT and receiver is Frsky D8RII plus
I am trying to setup PPM to work so it can control a custom bait boat using a control board from SP Tackle, I have attached there manual,
I've tried various settings but cannot seem to control anything, could do with some help please.
Thanks John
Setup PPM on 9xr pro
-
- Posts: 97
- Joined: Fri Sep 08, 2017 6:53 pm
- Country: United Kingdom
- Location: Bordon, Hampshire, UK
- Contact:
Setup PPM on 9xr pro
- Attachments
-
- UCB Quick Start Manual Issue 1.pdf
- (542.5 KiB) Downloaded 243 times
- MikeB
- 9x Developer
- Posts: 17993
- Joined: Tue Dec 27, 2011 1:24 pm
- Country: -
- Location: Poole, Dorset, UK
Re: Setup PPM on 9xr pro
It looks like you need a CPPM signal, from the Rx, that contains all 8 channels. Unfortunately the D8R-II plus doesn't provide this.
I believe that you may flash the Rx with the D8R-XP firmware, then you are able to get a CPPM signal. Have a look at this thread: https://openrcforums.com/forum/viewtopi ... 96&t=11381.
Mike
I believe that you may flash the Rx with the D8R-XP firmware, then you are able to get a CPPM signal. Have a look at this thread: https://openrcforums.com/forum/viewtopi ... 96&t=11381.
Mike
erskyTx/er9x developer
The difficult we do immediately,
The impossible takes a little longer!
The difficult we do immediately,
The impossible takes a little longer!