Variable Rates with 2 Elevator Servos not working

Post Reply
schke07
Posts: 1
Joined: Wed Aug 17, 2022 4:14 pm
Country: -

Variable Rates with 2 Elevator Servos not working

Post by schke07 »

I have set this up for a single elevator servo without problem on many models.
Now I have a model with 2 elevator servos.
The 2nd elevator is using CH6 while the other continues to use CH2.
I copied the INPUT settings for the variable rates from CH2 (Elevator) to CH6 (Elevator 2).
The variable rates continue to work for the CH2 input, but do nothing for the CH6 input.
No matter the switch setting, the CH6 values remain at 100% and do not step down like CH2.

I am opentx version 2.3.14.

Any help mucho appreciated otherwise I cannot fly this model!!!
KEN

User avatar
Kilrah
Posts: 11108
Joined: Sat Feb 18, 2012 6:56 pm
Country: Switzerland

Re: Variable Rates with 2 Elevator Servos not working

Post by Kilrah »

It's not the input you want to duplicate, inputs are not tied to channels.
It's the mixer lines you have on CH2 you want to copy to CH6.
Post Reply

Return to “openTx model setup”