I have been reading all the literature and website I can find on OpenTX. For some weeks now..........and I will continue to do so.thebriars0 wrote: ↑Wed May 22, 2019 12:23 pmI think you need to read up carefully on OpenTX....................ThompsonJim wrote: ↑Tue May 21, 2019 10:21 pmI am sorry Martin, but I cannot understand one sentence of the above description!thebriars0 wrote: ↑Tue May 21, 2019 1:29 pm Basically this routine has no direct effect on the servo whatsoever.
All it does is sets the throttle channel to -100 no matter where the throttle stick is. Then once switch E is held down for between 3 and 5 seconds AND the throttle stick is fully down it will enable the throttle stick to work again. If the throttle is enabled, it works exactly the same to disable the throttle.
In the mixer page, L02 acts on the throttle input to disable or enable the input from the throttle stick.
Edit: That is not completely true. I do understand the first sentence.
That much at least, is self evident.It is very different to programming a normal transmitter, .................
Yes, many, many times.Have you tried working through the "Getting Started" section of the documentation.
Thanks Martin,
Jim.