Search found 7 matches
- Mon Apr 17, 2023 9:00 pm
- Forum: Hardware
- Topic: Taranis X9D+ not binding
- Replies: 2
- Views: 5098
Re: Taranis X9D+ not binding
I'm happy, I was able to solve the problem. I updated firmware from internal RF module, and started to work. Just in case, take care to install old version from firmware due to the new version only work for X type receivers. This is really bad from frsky!!!!!!!!! I have several Dx type receivers and...
- Mon Apr 17, 2023 3:26 am
- Forum: Hardware
- Topic: Taranis X9D+ not binding
- Replies: 2
- Views: 5098
Taranis X9D+ not binding
I forgot my Taranis X9D+ turned ON during nigth, I found it next morning doing a strange noise from speaker like battery low malfunction, so I turned OFF and put it to charge. Next day the radio lost all my binded planes. I tried to re bind all planes but it was not possible. I have several receiver...
- Tue Jun 16, 2015 7:26 pm
- Forum: openTx
- Topic: OpenTX 2.1 telemetry system preview
- Replies: 283
- Views: 327223
Re: OpenTX 2.1 telemetry system preview
This telemetry update is getting more and more similar to the DCS (Distributed control systems) industrial systems I use to work. I/O configuration, ranges, alarming, etc... I think that there are a few things that could be missing like "data quality" (it could be probably implemented), da...
- Thu Jun 11, 2015 3:22 am
- Forum: Hardware
- Topic: D8R Check both antennas are working
- Replies: 3
- Views: 2438
Re: D8R Check both antennas are working
I think that the best would be to connect the tube to electrical ground if you want to isolate the antenna.
- Fri May 29, 2015 8:16 pm
- Forum: Hardware
- Topic: Serial communication over Frsky Telemetry Link
- Replies: 11
- Views: 11011
Re: Serial communication over Frsky Telemetry Link
Thanks Kilrah, Now I understand, the air link is pretty slow. It is too slow that I would say that is almost obsolete for nowadays. I think that the purpose of this module is mainly to provide 2 analog inputs, additionally it has some spare bandwidth and provide serial link for any other data... Des...
- Fri May 29, 2015 6:20 pm
- Forum: Hardware
- Topic: Serial communication over Frsky Telemetry Link
- Replies: 11
- Views: 11011
Re: Serial communication over Frsky Telemetry Link
I don't understand... from the manual it is specified that the baud rate can be "reconfiguration" to 300bps, 600bps.... 9600bps
but then below in is written "Mode 2-> Bidirectional Max 90bytes/sec" which is almost unusable for any application...
but then below in is written "Mode 2-> Bidirectional Max 90bytes/sec" which is almost unusable for any application...
- Fri May 29, 2015 2:02 pm
- Forum: Hardware
- Topic: Serial communication over Frsky Telemetry Link
- Replies: 11
- Views: 11011
Serial communication over Frsky Telemetry Link
Having a look in Frsky products I found this set of converters. I was wondering if it can be used to send APM or any other FC telemetry data. I also was wondering if It could also be used to connect APM to Frsky system and show APM data in Taranis radio. "FrSKY S.Port To UART Converter (With 2 ...