openrcforums

This has probably been brought up before but I will ask anyway. How do you set the throttle trim as a gyro gain for a 450 size heli? I know you can use one of the variable pots but I would like to try to use the throttle trim. I was thinking of using a 2 position switch as the HH and Rate switch but...

Thanks for the replies. I have not been following this lately but I will try both suggections. Thanks

I need help with setting up er9x with Flymentor. I got a template off this site and modified/added what I needed for the flymentor. The problem I have is, when I try to center the servos via flymentor I have issues. When I adjust the pitch servo all servos move, when I center the pitch and try to ce...

Once I get more comfortable flying helis I will switch back. There is just too much going on with programing and learning to fly helis. I am cheating and using the Flymentor 3D on one copter and the CopterX 3100 FBL system on the other. I saw there are templates for the heli I have (HK450) but setti...

Showmaster has successfully fixed my screw up, thank you soo much.

Thanks pldb64. I downloaded that firmware once before and tried to load it and it would not work. I did like the post said, firmware then eeprom right after. This time it worked. Maybe the file got corrupt last time.

Thanks again for the help.

Does anyone have a copy of the original FlySky firmware? The main firmware and the eeprom firmware. I flashed my FS-TH9X with ER9X and did not realize I should have copied them from the TX via eepe.

Thanks

back on topic, I have fixed worse damaged board than that, by looking at the out of focus pic you posted, but a hires pic showing the damage can help to make a more accurate estimate if it is fixable. You are on the wrong side of the pond for me to offer help ( and my help is somewhat slow, ask som...

Here are some pictures of the board. Even if I could get it operational could I trust it? I think I might look for a new board or new Turnigy.

Thanks all for the help.

Crucial

Thanks for the relpy. I am glad i can bind Flysky RX's with Turnigy.

Showman, I think I am going to keep my SP board, what happen was; -I installed the SP board according to the instructions and youtube videos -Tried to connect to it with the eepe software and it kept coming up with the target not answering so I found this link (http://www.smartieparts.com/shop/index...

I am in dire need of a Flysky main board. I had a V1 board and tried to do the mod that smartieparts suggested to use the board but I was not successful. So if anyone has a V1 or V2 board please let me know.

Thanks
Joe