openrcforums

Hi. I have updated my 9X with ER9X firmware. It is working very well. Now I want to put the voice module: ArduVoice. I want to use an Arduino nano, since it has the USB connection to load the program. I have a LM386 amplifier board and mini SD board. I'll put everything out of the radio and then put...

I want to set 16 channels in the Taranis, using 2 receptors D8R II Plus.
1 receiver linked to the internal module and the other linked to the external module DJT.

As I assign each channel to each receiver ??

thanks

I have a taranis with firmware version "opentx-x9d-v1. 1.02 "and want to update to a new version v.2.09 Plus Taranis.

As I do ??

which are the steps to follow ?

thank you

I can update the firmware of my old Taranis (not Plus) by the new Open Tx 2.1.0 ?
If this is not possible which would be the last version which may be updated ?

Thank You

I changed the battery pack my Taranis by 8 NiMH cells to power the external RF module (not FrSky). I can use the charger that brings Ttaranis? Charging stops by current or voltage ??

Thank You

I changed the battery pack my Taranis by 8 NiMH cells to power the external RF module (not FrSky). I can use the charger that brings Ttaranis? Charging stops by current or voltage ??

Ok

thank you

I have the Corona system in a Futaba, and want to use receivers with tararnis.

Someone has used the Corona module CT8J in Taranis ??
Works well ??
Has good range ??

thank you

I want to connect a Corona module in my Taranis.
Which should be the parameters for the setup ??
ms ??
u ??
polarity ??

thank you