openrcforums

Yes sorry it was a typo

Edit got it to work. It was so simple. It seems like you can do anything with this fw once you understand the different functions. I'm gonna build a mix database with explanations just so noobs can reference when they want to do similar mixes

Hey guys I need some help. I have a T-28 with 2 rudder servos. I put the nose wheel servo (steering on the ground) on Ch7 and the tail rudder servo on Ch4. The gears are on Ch5. I'm trying to mix the nose servo to the tail rudder when the gears are down. Once the gears go up the nose steering should...

No, you could also adjust weight, offset and differential. - Set your switch in middle position, adjust offset - Set your switch to the position that requires the most excursion from center, adjust weight - Set your switch to the 3rd position, adjust differential. Thanks for this. I'm going to keep...

Romolo wrote:Use a curve, a 3 point one is sufficient -30,0,45

Thanks, is that the only way to do it with the 3pos switch

Another question. Since I use the 3pos switch for the flaps and it only goes from 100,0,-100, how do I make it so I can have say 30% and 45% amount of flaps

Ok Thanks guys I will try this when I get home.

Hey guys I just started using open9x and so far I really like it. I'm trying to mix in some down elev with the flaps on the 3pos switch. How would I go about doing it for each position.

Thanks

Ok thanks

Ok quick question again. Should I change it 10.8 v when the battery is fully charged? I just set it and when I loaded my eeprom into eepe, its not showing the correct voltage. When I try to change it in eepe, the most it will go up to is 9.9

Thanks for the quick response guys

Hey guys, I need some help. Hopefully someone can. I just got a brand new 1500 mah Life 3s battery from HK. Fully charged it is 10.8V. My Tx is showing the wrong voltage though. The Tx says 10.3v, but when I check the battery with my voltage checker, it shows that the battery is 9.8. Anyone have any...

Triple quote of posts directly above has been removed by your friendly MOD
Please post the file.

Thanks

Quote from post directly above removed by your friendly MOD
ok Thanks I'll just order one of the usb cords

Ok thanks Rob

I'm trying to get my head around all this. I just ordered another 9x that I will be doing the telemetry mod. I will be doing get the JR module instead of the diy version. After reading the wiki, I see that I would have to do some soldering. Is this only required if you want the telemetry data on the...

Also, when I plug the cable in, I get a buzzing sound from my speaker. Is there a fix for that?

I got it fix, however I cant get it to work in Phoenix. I'm guessing its because I'm not using a usb plug. I'm using the stereo cable plugged in the mic jack. I did get it to work with RF but no flaps or gear ch

Ok I got this to work with RF, but the rudder is on the right stick with the ailerons. Any ideas how to t fix?

Thanks

I noticed this is setup for helis. Will this work for planes too