openrcforums

I haven't been able to find a list of all of the Tx ready/BNF models that are compatible with the FlySky/Turnigy module. So, if people could list what models you have succesfully binded to the FlySky/Turnigy etc modules and any special issues(if any). So far, I have binded to the Align T-Rex 100s on...

Thanks! Deal made

Pm Sent

Just as the title says. looking for a 9x Tx module, preferably FlySky, but Turnigy would be OK for the right price. Might be interested in a trade. I have a 1980s K&B .20 glow made in the US. Only been run on a test bench long ago, never flown. Would trade the motor straight up for a FlySky/Eurg...

Note: I did have to adjust one setting. I made the alarm come on during startup with the throttle cut OFF rather than ON, for safety. But everything else seems perfect so far!

Very true jhsa. But it is quite easy to save a single model to a hex file, then copy and past it to another hex file. Anyway, this setup seems like it will work well. Seems to function very well, probably better than the Storm Tx setting. I can't take it outside yet, but everything seems to work gre...

I was able to use eepe to save it as a hex file, then opened it in companion and copied pasted to my current hex file. Seems that the settings are correct. I'll give it a try when the rain quits. lol

Thanks again!

I was told not to use eepe with Open9x. Is this not the case? I would rather keep Open9x.

Thanks for all your work, but I cannot get the file to load properly in companion. It opens as a blank file. What am I doing wrong?

gohsthb wrote:Do you have a link to a manual for this Storm controller. I'm not familiar with that heli at all.
-Gohst

http://www.helipal.com/images/Storm-tra ... manual.pdf
Thanks

Hello. I have a Storm 450 heli and I am a little confused on how to set up the pots and an idle switch, to match the Storm Tx. I used the Companion template for settup, and it seems to work well, except for the Gyro sensitivity, Pitch and idle switch. Basically I would like to set up P1 as the Gyro ...

9xR. While it is an interesting alternative, there are some issues with the first batch. Might want to check out the RCGroups 9xR thread here: http://www.rcgroups.com/forums/showthread.php?t=1628785

Thanks for the help. It must have been a bad setting. I got my smartieparts board today unexpectedly early and flashed open9x. The problem is now history with the new and improved firmware.

I just got a Turnigy 9x with FrSky DJT and V8FR-II Rx. Got it bound and operational, however the throttle does not function below about 40-50% of travel. How can I adjust this? TIA

Hello. I just got a Turnigy 9x and FrSky module w/ V8FR-II Rx. I have it bound(binded?) and operating, however the throttle is only opperational at about 40-50% throttle position. How can this be adjusted? I tried reading the manual(s), but could not figure it out. TIA