openrcforums

I’ve tested r12 with and R8PRO (2.4Ghz)
It was registered, binded and works fine.

I tried with and R9SX (868 MHz.) but I was not able to register.

Narcis.

The audio now always play.
Selection works fine with no ENC. as exit unselected.
Touch buttons in file list also works fine.

Narcis.

I tested Audiotest10.
It plays files but only after I run Audiotest2.

MikeB wrote: ↑Wed Jun 08, 2022 7:47 pm I assume the audio works correctly, for both of you, when you run ETHOS.

Mike

Yes, audio works correctly in Ethos.

Narcís

jurajjurej wrote: ↑Wed Jun 08, 2022 6:27 pm

Narcis wrote: ↑Wed Jun 08, 2022 3:07 pm This is my sd card

Thank you and it helped me.
I apologize for the bad English
But I meant SD content.

Don´t worry, my english is not very good either.

This is my sd card

jurajjurej wrote: ↑Wed Jun 08, 2022 2:51 am

Narcis wrote: ↑Tue Jun 07, 2022 10:03 pm All works fine except voice.

And what about the screenshot? When I set the switch everything goes wrong.

In my transmitter works fine.
I set the screenshot switch, activate several times, changed model settings (two models), changed displays, switched off the transmitter… all were saved.

All works fine except voice.

Hello Mike,

I’ve tested sd_test6 in my x20s.
Here you are the results.

Hi Mike,
I also have no audio output at all, even with trims. Volume set is at maximum: 23.
Audio files are in correct directories.

My X20 is an X20S.

Narcis.

I’ve this one (see photo) working fine in a x20s
I’ve binded with a jumper r8 and several multiplex receivers

Hello, I’ve changed RxV value in telemetry menu to 25.5 and now the displayed value for RxV is correct.

Hi Mike, I’ve found the servo delay cause. It’s the failsafe, I had failsafe in custom mode. In mlink it sends failsafe to receiver every 6-7 seconds, receiver blinks led (acknowledge way on multiplex receivers) and servo has a little delay. I’ve changed to receiver failsafe mode and servo delay dis...

Thank you Mike.
I’ve tested p3r8, now I display RSSI and RxV.
RxV seems to be half of the actual receiver voltage.

Hi, here I send raw log file

I’ve loaded p2r8 and tested with Rx-9, but I don’t receive telemetry, RSSI remains 0.

I tested this receiver with a jumper t12 pro transmitter with opentx 2.3.14 and multi protocol 1.3.3.7 where I correctly received telemetry. IrangeX IRX4 lite is 1.3.2.86 version. In mpm 1.3.2.58 was added telemetry forwarding to opentx in Mlink and in Opentx 2.3.12 was added telemetry support for M...

Hello, I’ve tested my X20S with ersky R7 and ethos 1.1.1 and several receivers : jumper r8 , multiplex rx-5, rx-6, rx-9. The tx module is IrangeX IRX4 lite. With jumper r8 all works fine, even telemetry : RSSI With multiplex receivers there is a little issue, I tested moving a servo from extreme to ...

I’ve a 32GB Sandisk Extreme (class 10) in my X20S.
All works fine.

I updated my X20S from R6 and 1.1.0 to R7 and 1.1.1.
I created the composite from a dual boot radio and all works fine.