Search found 4 matches
- Sun May 30, 2021 9:13 pm
- Forum: openTx model setup
- Topic: radiolink R8EF failsafe
- Replies: 2
- Views: 5794
Re: radiolink R8EF failsafe
I got response from Opentx guys. Channels 9-16 are failsafe. So configured channel 11 throttle failsafe (original throttle channel is 3, so 3+8=11) to -100. Will test. but probably working. This forum is so nice. I need to find what the problem is elsewhere.
- Sun May 30, 2021 9:11 pm
- Forum: openTx
- Topic: RadioLink T8FB - TX16S trainer
- Replies: 1
- Views: 2086
Re: RadioLink T8FB - TX16S trainer
Working with standard mono-mono cable. Or stereo-stereo cable + converter mono-4pin din. Only problem was tx16s. Connector must not be fully inserted. Just insert it a bit. I put some spacer to stereo connector, so connector is not fully buried to tx16s. Not perfect, but working.
- Thu Apr 15, 2021 9:00 pm
- Forum: openTx
- Topic: RadioLink T8FB - TX16S trainer
- Replies: 1
- Views: 2086
RadioLink T8FB - TX16S trainer
Hi, I have RadioLink T8FB and R8EF - TX and RX. And TX16S with R8EF or FRSKY S8R glider model. Is there any possibility to set this as wireless trainer mode? Or even wired trainer mode? - T8FB has round svideo. TX16S is using mono cable. I tried svideo - mono cable. With no luck. I did not saw Calib...
- Thu Apr 15, 2021 8:52 pm
- Forum: openTx model setup
- Topic: radiolink R8EF failsafe
- Replies: 2
- Views: 5794
radiolink R8EF failsafe
Hi, I have three RadioLink R8EF RX modules. I am able to bind it and fly with it. But as long as it loses signal (changing model on tx16s, turning tx16s off, tx16s too close to RX), throttle is 100% and prop is furiously spinning. Binding to RadioLink T8FB transmitter and FailSafe config is ok. Trie...