Search found 6 matches
- Sat Jan 16, 2021 1:09 pm
- Forum: OpenXVario - an open source vario supported by the open source firmwares!!
- Topic: Activating cell voltage measurement for/in OpenXSensor
- Replies: 11
- Views: 6345
Re: Activating cell voltage measurement for/in OpenXSensor
To be honest, total voltage is enough for me too. Usually no one uses batteries, if their cell voltages are significantly off, so that they need to be monitored. But since openXsensor supports it, I wanted to try/use it and it works very nicely. This way I have basically combined the functionality o...
- Fri Jan 15, 2021 9:09 pm
- Forum: OpenXVario - an open source vario supported by the open source firmwares!!
- Topic: Activating cell voltage measurement for/in OpenXSensor
- Replies: 11
- Views: 6345
Re: Activating cell voltage measurement for/in OpenXSensor
I'm an idiot! :) Everything is working fine now, the error was mine. I had two different directories of openXsensor and the one I was editing wasn't the one I was compiling and flashing to the board. The vario worked, since it was the default setting anyway. But as soon as I saw the debug output, I ...
- Fri Jan 15, 2021 8:41 pm
- Forum: OpenXVario - an open source vario supported by the open source firmwares!!
- Topic: Activating cell voltage measurement for/in OpenXSensor
- Replies: 11
- Views: 6345
Re: Activating cell voltage measurement for/in OpenXSensor
Thank you for testing it! I didn't know about the debug function, will enable that too and check out if I get the same info or not.
- Fri Jan 15, 2021 1:43 pm
- Forum: OpenXVario - an open source vario supported by the open source firmwares!!
- Topic: Activating cell voltage measurement for/in OpenXSensor
- Replies: 11
- Views: 6345
Re: Activating cell voltage measurement for/in OpenXSensor
Yes, I have searched for new sensors every time I tried new settings. I also tried deleting all first. I will test another receiver, since that's something I tried not, yet. The offset and scale lines were active and set to 0 and 1, respectively. I only commented them out later, after reading that t...
- Fri Jan 15, 2021 9:23 am
- Forum: OpenXVario - an open source vario supported by the open source firmwares!!
- Topic: Activating cell voltage measurement for/in OpenXSensor
- Replies: 11
- Views: 6345
Re: Activating cell voltage measurement for/in OpenXSensor
Sorry for posting the full config files, I should have attached them! And of course I'm using voltage dividers to bring the voltage down to a range between 0 and 1.1 Volts. As I've described above, this works fine and doesn't seem to be the issue. The problem is, that I can't get the firmware to dis...
- Thu Jan 14, 2021 8:02 pm
- Forum: OpenXVario - an open source vario supported by the open source firmwares!!
- Topic: Activating cell voltage measurement for/in OpenXSensor
- Replies: 11
- Views: 6345
Activating cell voltage measurement for/in OpenXSensor
I'm using an Arduino Pro Mini with a MS5611 IC and some voltage dividers connected to the A0-A3 pins on the Pro Mini. The variometer function seems to work fine (Alt values rise and fall when moving the sensor) and I also successfully tested getting the ADC values from the A0-A3 pins with a simple A...