openrcforums

Hello Mike, Thanks for these files. I tryed opentx-x9D2019-2-3-15a-choice-lua.zip It solves my receiver recognition problem (ARCHER PLUS GR8) from OTA function. it works :lol: :P I suppose that if it works now, it was a problem compiling with data from recent receivers :? I dont know if it works wit...

thank you very much Mike.
I will try it soon and get back to you
kind regards
Gilles

Hello, I use transmeter X9D+2019SE, under openTX V2.3.15-otx (1004ef7c) Recently, I bouth ARCHER PLUS GR8 (with OTA) and i'm unable to update FW with OTA Protocol (no line "update with OTA in the menu) :( But Update is successfull with wire from transmeter. ;) Update with OTA is successful wit ...

Great, ChrisOhara,
i'll probably try these solutions.
thanks wery much,
i'll keep you posted
regards
Gilles

ChrisOHara,
witch kind of sensor did you use on Rcexcl signal ?

Hello ChrisOHara,
thanks for this very interesting answer.
witch value or resistor did you use (aproximatively) ?
placed on the line of pin 8 i suppose ?
sorry for these questions, i do not speak currently eletronics
regards
Gilles

Hi,
Does somebody have an idea ?
Does somebody have any experience about this kind of sensor ?
Regards
Gilles

Ok, i see,
good for him, bad for us
is there anybody left to take care of oXS ? i mean for any maintenance or modifications

Hello everybody,
Does anyone have news from Michel Strens ?
His account has been inactive since November 23, 2020.
I am worried about him.
Does he have personal problems? health concerns ? or so one ?
regards
Gilles

Hello every boby, I built a RPM sensor with oXs, arduino and Infrared Obstacle Avoidance Sensor Module. It almost always works well, except for a few overspeed spikes I read eccentric measurements at start-up, or at a sudden go-around (excuse my poor english, i use google translation), sometimes mor...

I would like to know what is happening when you switch on or of range chek, regarding servos control

had you tried range check in your last configuration ?

Hello, i asked question for FRSKY support and just received answer : "If you want to use redundance function with R-X8Rpro receiver, you only connect the servo channels from RX8R receiver(master receiver). When both receivers are working, the output signal is from the master receiver. when the ...

Hello mstrens, i finaly cut the pcb arround 4525D sensor, and used it with a new arduino openXsensor had been upload with a single 4525D configuration on smart port. it works :D , it's recognized by frsky X9D transmeter and I hope the information is correct :) . I'll soon test it in my car here are ...

If you prefer, you can send me private messages in French (it is my mother langage). I expect that the AVR328P has some internal fuses that can be activated in order to protect it. As alyernative, you can a new arduino pro mini (at about 2 €) and build an aispeed sensor with oXs reusing the 4525D s...

Thank you Kilrah,
i have no knowledge to do your purpose,
i'll probably prefer mstrens's solution.
regards

Hello, I'm just discovering OpenXsensor , Arduino and theyre fantastic possibilities :roll: I made two ACS712 5A sensors with many difficulties and the great help of this forum and the French forum <E>:roll:</E> frskytaranis.forumactif.org. I now consider Airspeed Sensor N2 Industries type SA02. It ...