Thanks a lot.
But I think I made a mistake and got a short circuit between the vcc pin a the one just next, than I burnt out a track that will be hard to fix because is under the processor.
Again, thank you guys.
Search found 7 matches
- Fri Nov 02, 2018 5:32 pm
- Forum: Hardware Mods
- Topic: Flash M128 Turnigy 9x
- Replies: 19
- Views: 16044
- Thu Nov 01, 2018 10:32 pm
- Forum: Hardware Mods
- Topic: Flash M128 Turnigy 9x
- Replies: 19
- Views: 16044
Re: Flash M128 Turnigy 9x
Hey João,
I did not find any setup up related to processor. Only the "settings" where I can choose the radio (settings->settings) and I did choose the "OpenTX for M128 / 9X board"
I did not find any setup up related to processor. Only the "settings" where I can choose the radio (settings->settings) and I did choose the "OpenTX for M128 / 9X board"
- Thu Nov 01, 2018 9:35 pm
- Forum: Hardware Mods
- Topic: Flash M128 Turnigy 9x
- Replies: 19
- Views: 16044
Re: Flash M128 Turnigy 9x
I just tried the fuses on read/write menu but the companion is not understand that I am trying to write the M128 instead of M64: ================================================================================= Started AVRDUDE C:/Program Files (x86)/OpenTX/Companion 2.0/avrdude.exe -c usbasp -p m64 ...
- Thu Nov 01, 2018 5:11 pm
- Forum: Hardware Mods
- Topic: Flash M128 Turnigy 9x
- Replies: 19
- Views: 16044
Re: Flash M128 Turnigy 9x
Thanks fxshoppe.
I'll try later and tell you the results.
I'll try later and tell you the results.
- Thu Nov 01, 2018 11:15 am
- Forum: Hardware Mods
- Topic: Flash M128 Turnigy 9x
- Replies: 19
- Views: 16044
Re: Flash M128 Turnigy 9x
Hi Kilrah, First of all thanks for your answers. I just saw some old posts of yours that mention that I should use the the option -B 100 to slower down the clk and if I got the feedback "warning: cannot set sck period. please check for usbasp firmware update." it means that I should try ot...
- Thu Nov 01, 2018 1:24 am
- Forum: Hardware Mods
- Topic: Flash M128 Turnigy 9x
- Replies: 19
- Views: 16044
Re: Flash M128 Turnigy 9x
How can I do that?
- Wed Oct 31, 2018 11:01 pm
- Forum: Hardware Mods
- Topic: Flash M128 Turnigy 9x
- Replies: 19
- Views: 16044
Flash M128 Turnigy 9x
Hi, I had to change the original Atmega64 from my turnigy 9x and then I installed the Atmega128. I was able to flash as follow: C:\Program Files (x86)\OpenTX\Companion 2.0>avrdude.exe -c usbasp -p m128 -B 100 -U flash:w:C:/temp/opentx-9x128-frsky-en.hex:i avrdude.exe: set SCK frequency to 8000 Hz av...