openrcforums

MikeB very thank You for the advice. The RX works well now. I set it to user mode and after communication break is switching off the motor a setting up the stabilization.
Jirka

Thank you for answer. Unfortunately, upgrading the firmware to version 221F4 did not help. It seems to me that only the failsafe mode can be selected. For me, either RX or user mode would be appropriate. Unfortunately, I'm not able to set up the failsafe mode on the receiver, so I can not use it now...

To the second question:
You can use simple integrated circuid with ofset and amplification, to can set output in the range 0 - 5V. But this solution will not be too precission and not too noise resistant .
Better is sove it digitaly.

Thank for your answer Mike. I have ersky9x-R220. Module XJT
Jirka

Hi I would like to set failsafe mode on RX S8R. I tested all modes in menu Protocol -> failsafe and I can't set, when RX loose signal, switch off the trotle and switch on the stabilization. Can You help me?
Thank you Jirka