openrcforums

That still didn't produce any light. I consider this module to be dead because there wasn't any voltage going to the led. I know that voltage is going in but nothing. I tried to flash it but it failed. I also ripped the ground pad off unfortunately but I still think it connects on the other side of ...

Before I flashed the bootloader the led would be on constantly and it also worked with opentx 2.2.1 and with the old bootloader. I'm unsure if its the new bootloader or the firmware that is messing it up. I no longer have the sd card contents of the original boot loader nor can I get back to the old...

yes the multimodule is in use. The led does nothing.

Hello, I flashed a green orange module a while back and I was using ersky9x on my taranis x9d+. I have now updated the firmware and bootloader to 2.2.1. Now the module wont work with either ersky9x or opentx. How do I get the module to work on opentx 2.2.1?

How do you add notes in ersky9x?


Sent from my iPhone using Tapatalk

Never mind I figured it out. Thank You so much I'm so happy. [emoji106][emoji106][emoji106][emoji106]


Sent from my iPhone using Tapatalk

It works with ersky9x. Why is the channel mapping ETAR? How do I change it


Sent from my iPhone using Tapatalk

It's in the most current version of OpenTx


Sent from my iPhone using Tapatalk

It will be like this on the transmitter screen
Module Status: No Multi_telemetry


Sent from my iPhone using Tapatalk

I flashed the module a little while ago with a code that should work. I tried it today and I can't get my Nano Qx to bind. It will only stay in bind mode no matter what I try. What am I doing wrong? The code is 1E95-4201-00BF-FEFF-00FF. I'm using a Taranis x9d plus with a green module. The module is...

does the code 1E95 4201 00BF FEFF 00FF mean that it worked. I don't have a way of testing it since I broke the attenna wire off right at the attenna connector

I'm also using the module bay as the power source

Plus

So i flashed it and it said "flashing complete" and below it "failed" with a error code of all 0's. Did it work?

I did make a Firmware folder and that worked. Now I can't seem to power on the module with a receiver battery consistently. It works with the transmitter but not with a external battery. How did you do it?

There is only a firmwares folder.

In the maintence menu on ersky9x it says no files on any of the options and the number 1 to the right of the No Files. I put the files in the firmware folder when the Taranis in connected to my computer. Please Help

Thank You

What file do I use for the flashing? Also what file in your other forum of many many ersky9x files do I use?

Ok now I see them Thank You

Thanks for the response by I don't know where to jump the two places where the resistors are supposed to go

I have a couple questions still. Where do I bridge resistors 1 and 13 to. Also what does JTCK and JTMS go to on the green module? Three wires come from the Taranis Motherboard and there are four pads to connect to on the module. Where is the fourth wire?

Thanks

Is it possible to flash a OrangeRx Tx Module with a Taranis X9D plus with OpenTx? Do I need a special programmer? Do the wires from the Taranis motherboard go straight to the Module? Can you list the posts or steps to do this please? Thanks

Can I flash a green tax module with a Taranis x9d plus using open tx? Also can you give me the steps to reflashing the module? Does the wires from the Taranis go directly to the module? Do I need a special programmer? Thanks a lot