openrcforums

Hi Mike
Thanks for the info, done it and yes it works.
I have managed to read the orginal firmware and write ersy9x to the jumper.
I have set a model up but not tried to bind to an RX yet will have to see how it goes.
Again thanks for your help with this

Hi Mike
Please see attached images one showing the firmware installed which is the Jumper TX and the second showing the drive letters assigned when the TX is connected via USB.
Thanks

Hi Mike Thanks for the info, unfortunatley I am drawing a blank when trying to flash the T16, using EEPESKY I get the TX disk not mounted message, have tried updating EEPESKY but again the same happens. When I put the .bin file in the firmware folder and try to flash from bootloader menu I get a str...

Hi I hope this is posted in the correct thread if not sorry for this. After many years using my Turnigy Xr pro with ERSKY 9x firmware I have purchased a Jumper T16 and the radio is absolutly great, the only issue is I am struggling with certain aspects of Jumper Tx and would really like to install E...

Hi Mike You can re assign thr GUID of the module by using the bottom button, I did this a couple of times with no effect, I re checked tonight and both the DSM2 Rxs are still working fine, I a a little bit hesitant to change anything other than the settings in the model just in case everything falls...

Hi Mike I have another update, I decided to go back to my original firmware just to see if this settled down the telemetry screen, I copied everything back to the sd card after first having deleted its content. I tried one of my 1024 22ms rxs with telemetry and this bound and worked fine, I then dec...

Hi Mike Thanks for the response it would appear on the face of it that the module and telemetry is working fine with the early rxs so I will probably use this in one of my battered sacrificial modules to see if range etc in their is good. I just cant fathom the ghosting on the screen as It wasn't th...

Hi Guys I have tried the latest experimental firmware without success in fact the module stopped transmitting at one point even though the prtocol settings were correct, I have returned to the r220 firmware and the results are back to how they were in the begining. I have another wierd thing happeni...

Hi Mike Thanks for the responses, I made a new model and set everything up as advised, have tried a dmsx rx still no joy will try a 2048 11ms tommorow evening to see if this binds up and works ok but I suspect it will not. I will try using one of the prototype firmwares if no success, when you say b...

HI Mike
From my Tx screen as follows

versiom V.1760-Mike
date 04.12.2016
time 10:18:39
sun ersky9x-r220
mod REVB-X
Cheers
Phil

Hi Mike Just a quick update, I have now found the bind option on the TX by enabling the internal module (not that I have one installed) though this appears to have no effect on the orange telemetry module when i use it the TX says binding but it does not force the module into bind which does not com...

Hi Mike I have the protocol set to dsm2 chans 12, dsm type 9xr-dsm and have tried using the trainer switch and bind button on the module, i cant find the bind option from the radio menus since I updated the firmware, prior to the update though this did not put the module into bind. I know the module...

Hi Mike

Its the module that uses the internal antenna

Thanks

Hi All First can I say thanks to everyone for the useful information on the forum. Now onto a starnge problem I have with my 9xr pro and the orange telemetry module, I have this set this up with all the settings as advised and have flashed the new firmware and voice packs to the TX, the problem i ha...