openrcforums

Hi MikeB,
I fine the new TGY 9X on HOBBYKING Website.It use new kind module. The new Turnigy 9X hardware can use ER9X ? The module use PPM or Sreies interface ?

Hi guys ,
I use a multiprotocol 4 in 1 Module in 9XR RPO with ersky9x R220 and use the Flysky AFHDS2A with Sub_protocol PWM_IBUS protocol.
The 9XR PRO can bind the Flyskyi10 receiver and work well.But I don't know how to set the F/S function.Does it have the F/S function?

Hi MikeB,
I don't understand "Capacity Alarm" but it defult "50" after firmware R220 upgraded.
Now I set "Capacity Alarm" at 0 ,the warning voice was gone.
How to use "Capacity Alarm" ?

Hi Jhsa,
I have installed the new voice pack.But I have another problem.The better warning voice always exist in no warning situation.After turning on voice,the radio always say"Radio Battery Low".I am sure that the bettery warning is not active.How to solve it?

I upgraded to firmware R220 my 9xr pro. I'm using the OrangeRX 2.4Ghz Telemetry Module For Turnigy 9XR Pro (DSMX/DSM2/Walkera Compatible).https://hobbyking.com/en_us/orangerx-2-4ghz-telemetry-module-for-turnigy-9xr-pro-dsmx-dsm2-walkera-compatible.html I had a problems. The voice function was disabl...

Hi Kilrah,
In manual it said support 6-12channel.
module:http://www.hobbyking.com/hobbyking/stor ... 272X50.pdf
show that
Connector P1 Pin description:
PIN1- PPM signal, TTL 5V, 6-12 channels
So I think the module support 12 channels.

Hi MikeB, I try the the frame length 30mS with 9XR and 9XR PRO but the 10th-12th channel still don't work. In 9XR and 9XR PRO I use " 1st Chan 1 " proto PPM 12CH 300uS PPM FrLen 30.0mSec Polarity POS How to sovle the problem?

Hi Mike,
Yes,it is a 'ordinary' Orange module.
I use frame length 22mS because the user manual show output protocol DSM2 22mS/11mS ,DSMX 22mS/11mS.
Should I increase the frame length to around 30mS ?
I will try 30mS later.Thanks.

I used the Orange module in my 9XR pro and 9XR but just can use 1-9 channel. How to setup the protocol ? I use PPM 12CH but it can't work. When I used the same receiver with Spectrum DX18,all channels work. module:http://www.hobbyking.com/hobbyking/store/uploads/1018410990X893272X50.pdf receiver: ht...

I think TGY-i10 is a good transmitter but I can't find its custom firmware like er9x.