openrcforums

phoenixangel wrote:I replaced the r9 current sensor and the mosfet, wired it back to factory and had to replace the main power switch. I now have a perfectly fine radio again. Thank you so much guys !!!

Where did you get the replacement parts?



Sent from my P80h(D4C4) using Tapatalk

I too am surprised. Prior to looking at the 9xtreme board as having an issue, I was sure it was the radio itself causing the problem, since it was the only thing I was touching. Everything was fine following the installation of the board, and I cannot think of, or remember any event that could have ...

Great, I'll reply soon. My mail server is slow today.

Soldering a wire to the pin and pad beside the broken one did not result in a difference. I have emailed Steven, and also ordered another radio.

Mike, I did what you said and soldered the soldered the pin to pad locations with a wire. The 9x boots up all the way to the normal display and I can move the throttle and sticks and see the corresponding display bars move. However the menu, exit, and other buttons do not allow navigating to any oth...

I'm looking for a diagram which shows which pad I should wire to from the broken pin. Just so I don't have to trust my eye.

Ok, found the first problem. Note that everything was working fine with 9xtreme board a few days ago. One of the pins on the 9xtreme is broken off. http://images.tapatalk-cdn.com/15/12/06/e6b49b4084b91176a8e0e3d05c84e5db.jpg I do not have the skill to solder this on so I tried putting it in place an...

Thanks all. Mike, now when I switch it on the screen displays "9Xtreme" in the center and r00.3 in the bottom left corner. If I do the trims in power on, the same display appears but the background changes from green to red/purple Connecting by USB to my MacBook, the two folders appear. I ...

Well, I am pretty sure I have damaged something I can't repair on my Flysky 9x bought at BG. This after getting the 9xtreme and other mods working, and installing the internal DHT module. Now it's stuck on the boot loader screen. While I am still able to connect by USB, the buttons, switches stopped...

Thank you.

Do you know of a cable that we can use to replace the original 9xtreme wires and header, maybe even longer?
I would like to have a fallback before cutting the original one, even though only one side is being cut and rewired.

It was, is no longer. I need a replacement, or other option to communicate from PC/Mac to 9x

I installed the 9xtreme with the Frsky DHT Diy module inside and the DJT module outside. Problem now is I have lost the microUSB header that connects to a 4-wire USB connector cable. Can anyone advise on a solution.