openrcforums

Just bond my er9x using DJT module and a V8FR rx. The Rx red flashing and indicated bond successfully. But when go into normal op, rx red stays on, the servo on rx resoponded normally to command. However, according to the Frsky manual the rx green light should be flashing when command is received. I don't see any green light is on at all on rx.
Is this normal? or another manual mess up?

The flashing is very faint, you need to look for it to see it.

well, it seems there is a tiny tiny greenish dot, the red is so bright. no way for my eye to see it for sure. even with a magnifier. can't tell it is a green light or just a reflective dot. for get about seeing it flashing. but I will take your word for it. since all chs seem to operates normally. Thx.

yeah, the green LED just flickers.

Just did my setup with DJT and V8FR-II. That flickering green got me nervous, why is it not steady? I had to google to make sure it is just fine like that

In my dht the led was not well soldered, the green led was always off