OpenTX 2.2.2: Horus X12S 6 Position Switch 2 positions only
Posted: Tue Aug 14, 2018 4:20 am
I just purchased a used Horus X12S and installed OpenTX 2.2.2 on it this morning. I have been through the calibration setup several times but I am unable to get the 6 position switch to work properly. Position 1-5 are all detected as 1 and 6 is detected but does not show on the switch position sensor screen. It will not calibrate beyond 1. When I go to the MIXER screen and setup the switch to a channel and then rotate the switch, the switch shows -100 at the bottom until I hit position 6 and then it say 100.
While I was configuring channel 7 (where I want the 6 position switch), I highlighted the SOURCE and I have to rotate the 6P all the way from 1 to 6 to get the SOURCE to detect it. Also when I try to configure SPECIAL FUNCTIONS I am only seeing 6P1 and 6P2, 6P3-6P6 are all missing. Not sure what is up. Is this a bad switch, or something odd in how OpenTX has enumerated the switch. NOTE: In the HARDWARE screen under POTS 6P is listed as Multipos Switch.
Dont have a lot of hair to pull out of my head anymore , looking for some direction...
While I was configuring channel 7 (where I want the 6 position switch), I highlighted the SOURCE and I have to rotate the 6P all the way from 1 to 6 to get the SOURCE to detect it. Also when I try to configure SPECIAL FUNCTIONS I am only seeing 6P1 and 6P2, 6P3-6P6 are all missing. Not sure what is up. Is this a bad switch, or something odd in how OpenTX has enumerated the switch. NOTE: In the HARDWARE screen under POTS 6P is listed as Multipos Switch.
Dont have a lot of hair to pull out of my head anymore , looking for some direction...