After reading a lot of posts I decided to write this one because I'm clueless and I don't want to do something wrong with my transmitter.
I have :
- a Turnigy 9X v2
- a smartieparts v2.4
- a mac with Maverick
Software :
- eepe
-companion9x
I installed easily the board on the T9X without any problem.
When I try to flash the firmware with eepe (or companion9x), I have the "classic" :
Code: Select all
avrdude: error: programm enable: target doesn't answer. 1
avrdude: initialization failed, rc=-1
Double check connections and try again, or use -F to override
this check.
I checked the nylon spacers and two of them were longer than the 3rd one in a way that pins were barely longer than the spacer. I filed them down (less than 1mm) to have 3 equal spacers but still the same error.
I started to try random "stupid" things (Tx on/off ; with or without battery) so before messing everything up I decided to write this post
Thanks a lot,
Antoine