Hi,
I'm thinking of replacing the four select buttons on my 9XR Pro with a rotary switch same as used to be done on the 9X.
Is it possible to wire all seven switch functions as it was on the 9X or are only the rotary switch functions through J1B available?
I have the v.1.1 board.
Cheers,
David
7-way Rotary Encoder
7-way Rotary Encoder
- Attachments
-
- 20150915_164615_preview_featured.jpg (113.15 KiB) Viewed 4293 times
-
- Rotary.png
- (760.4 KiB) Not downloaded yet
- MikeB
- 9x Developer
- Posts: 17994
- Joined: Tue Dec 27, 2011 1:24 pm
- Country: -
- Location: Poole, Dorset, UK
Re: 7-way Rotary Encoder
Yes, the 4 direction switches should wire in to the existing 4 direction buttons, and the encoder and centre button wire in as well.
Mike
Mike
erskyTx/er9x developer
The difficult we do immediately,
The impossible takes a little longer!
The difficult we do immediately,
The impossible takes a little longer!
Re: 7-way Rotary Encoder
Thanks for the response Mike,
I've been away hence the slow reply.
So it's solder fly leads to the PCB. I couldn't see any headers that seemed relevant but wanted to check to be sure.
Cheers,
David
I've been away hence the slow reply.
So it's solder fly leads to the PCB. I couldn't see any headers that seemed relevant but wanted to check to be sure.
Cheers,
David
- MikeB
- 9x Developer
- Posts: 17994
- Joined: Tue Dec 27, 2011 1:24 pm
- Country: -
- Location: Poole, Dorset, UK
Re: 7-way Rotary Encoder
Yes, solder 4, fly-leads to the PCB.
Mike
Mike
erskyTx/er9x developer
The difficult we do immediately,
The impossible takes a little longer!
The difficult we do immediately,
The impossible takes a little longer!