Replace RS with momentary switch Taranis X9D?
-
- Posts: 277
- Joined: Sun May 06, 2012 8:37 pm
- Country: -
- Location: Fond du Lac, WI
Replace RS with momentary switch Taranis X9D?
Is it possible to swap a momentary switch for RS? I'd like an additional momentary switch, not just moving SH.
-
- Posts: 121
- Joined: Wed Dec 02, 2015 9:25 pm
- Country: United Kingdom
Re: Replace RS with momentary switch Taranis X9D?
I replaced one of the three position switches with a second momentary switch. Quite easy, a bit of soldering, and reconfigure OpenTX to recognise the new momentary. Would this help?
-
- Posts: 277
- Joined: Sun May 06, 2012 8:37 pm
- Country: -
- Location: Fond du Lac, WI
Re: Replace RS with momentary switch Taranis X9D?
I suspect that replacing a pot would require matching resistance at either end of the travel. I was hoping someone had done it and knew for sure.
Re: Replace RS with momentary switch Taranis X9D?
Resistance at end of travel is 0...