Just bond my er9x using DJT module and a V8FR rx. The Rx red flashing and indicated bond successfully. But when go into normal op, rx red stays on, the servo on rx resoponded normally to command. However, according to the Frsky manual the rx green light should be flashing when command is received. I don't see any green light is on at all on rx.
Is this normal? or another manual mess up?
Frsky rx green light not flshing
Re: Frsky rx green light not flshing
The flashing is very faint, you need to look for it to see it.
Re: Frsky rx green light not flshing
well, it seems there is a tiny tiny greenish dot, the red is so bright. no way for my eye to see it for sure. even with a magnifier. can't tell it is a green light or just a reflective dot. for get about seeing it flashing. but I will take your word for it. since all chs seem to operates normally. Thx.
Re: Frsky rx green light not flshing
yeah, the green LED just flickers.
My er9x/Ersky9x/eepskye Video Tutorials
https://www.youtube.com/playlist?list=PL5uJhoD7sAKidZmkhMpYpp_qcuIqJXhb9
Donate to Er9x/Ersky9x:
https://www.paypal.com/cgi-bin/webscr?cmd=_s-xclick&hosted_button_id=YHX43JR3J7XGW
https://www.youtube.com/playlist?list=PL5uJhoD7sAKidZmkhMpYpp_qcuIqJXhb9
Donate to Er9x/Ersky9x:
https://www.paypal.com/cgi-bin/webscr?cmd=_s-xclick&hosted_button_id=YHX43JR3J7XGW
Re: Frsky rx green light not flshing
Just did my setup with DJT and V8FR-II. That flickering green got me nervous, why is it not steady? I had to google to make sure it is just fine like that
-
- 9x Developer
- Posts: 1109
- Joined: Sat Dec 31, 2011 12:11 am
- Country: -
- Location: Massa (MS), Tuscany, Italy
Re: Frsky rx green light not flshing
In my dht the led was not well soldered, the green led was always off