I am running OpenTX Companion 2.0.19 with SAM-BA 2.15 on a Win 7 computer.
Transmitter is Flysky TH-9X with Smartyparts 2.4 board
Trying to flash OpenTX
Windows Device Manager tells me that I have a USBasp type libusbK USB... device (my TH-9X with Smartyparts) installed and working properly, located at Port_#0001.Hub_#0001.
In the OpenTX 2.0.19 "Settings" tab, "Configure Communications" asks for "Port". If I enter "Port_#0001.Hub_#0001" and try to write the .bin file to the transmitter, SAM-BA tells me the connection was "not found" and "SAM-BA done with errors".
What would be the correct "Port" name to satisfy SAM-BA and how do I find that "Port" name?
BTW - Running SAM-BA 2.15 alone gives me no choice for "Select the connection" as though it can't see the transmitter.
Zadig can see the transmitter @ USB ID 03F0 171D with a libusbk (v3.0.7.0) driver. Or I can change drivers with Zadig to give me "SmartieParts 9X Programmer (USBasp)" with "libusb-win32 driver" at "Port_#0002.Hub_0001" in Device Manager.
What do I tell SAM-BA?
Jameser -
SAM-BA wants to know port ID
- MikeB
- 9x Developer
- Posts: 18000
- Joined: Tue Dec 27, 2011 1:24 pm
- Country: -
- Location: Poole, Dorset, UK
Re: SAM-BA wants to know port ID
SAM-BA and Zadig are for ARM processors. You have a 9X with an AVR processor. This uses AvrDude to communicate.
You probably haven't selected the correct target device in Companion.
Mike.
You probably haven't selected the correct target device in Companion.
Mike.
erskyTx/er9x developer
The difficult we do immediately,
The impossible takes a little longer!
The difficult we do immediately,
The impossible takes a little longer!